D-Link Dis-200G Series Cli Reference Manual page 101

Default
The LLDP states is disabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline
Use the snmp-server enable traps lldp command to enable the sending of LLDP notifications.
Example
This example shows how to enable the LLDP trap.
Switch# configure terminal
Switch(config)# snmp-server enable traps lldp
Switch(config)#
20-3 show lldp
This command is used to display the Switch's general LLDP configuration.
show lldp
Parameters
None.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command is used to display the LLDP system's global configurations.
Example
This example shows how to display the LLDP system's global configuration status.
Switch#show lldp
LLDP Configurations
LLDP State : Disabled
DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
97