D-Link Dis-200G Series Cli Reference Manual page 172

32-8 show snmp
This command is used to display the SNMP settings.
show snmp {community | host | view | group | engineID }
Parameters
community
host
view
group
engineID
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline
This command displays the SNMP information.
Example
This example shows how to display SNMP community information.
Switch# show snmp community
Codes: ro - read only, rw - Read Write
Community
------------------------------- ------
public
private
Total Entries : 2
Switch#
DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
Specifies to display SNMP community information.
Specifies to display SNMP trap recipient information.
Specifies to display SNMP view information.
Specifies to display SNMP group information.
Specifies to display SNMP local engine ID information.
access view
------
ro CommunityView
rw CommunityView
168