D-Link Dis-200G Series Cli Reference Manual page 202

Parameters
device
interface
INTERFACE-ID
,
-
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display the surveillance VLAN configurations.
The show surveillance vlan command is used to display the surveillance VLAN global configurations.
The show surveillance vlan interface command is used to display the surveillance vlan configurations on the
interfaces.
The show surveillance vlan device command is used to display the surveillance device discovered by its
OUI.
Example
This example shows how to display the surveillance VLAN global settings.
Switch# show surveillance vlan
Surveillance VLAN ID
Surveillance VLAN CoS : 5
Aging Time
ONVIF Discover Port
Log State
Member Ports
Dynamic Member Ports
Surveillance VLAN OUI :
OUI Address
----------------- ----------------- --------------- --------------
28-10-7B-00-00-00 FF-FF-FF-E0-00-00 D-Link Device
28-10-7B-20-00-00 FF-FF-FF-F0-00-00 D-Link Device
DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
Specifies to display the learned surveillance devices information.
(Optional) Specifies to display surveillance VLAN information of
ports.
(Optional) Specifies the port to be displayed.
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No space is allowed before and
after the comma.
(Optional) Specifies a range of interfaces. No space is allowed
before and after the hyphen.
: 100
: 30 minutes
: 554
: Enabled
:
:
Mask Component Type Description
198
IP Surveillance Device
IP Surveillance Device