D-Link Dis-200G Series Cli Reference Manual page 21

3-4 show users
This command is used to display information about the active lines on the Switch.
show users
Parameters
None.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command displays information about the active lines on the Switch.
Example
This example shows how to display all session information.
Switch# show users
ID Type
-------------------------------------------------------------------------------
0 * console admin
Total Entries : 1
Switch#
3-5 terminal length
The command is used to configure the number of lines displayed on the screen. The terminal length command
will only affect the current session. The newly created, saved session terminal length will use the default value.
Use the no form of this command to revert to the default setting.
terminal length NUMBER
no terminal length
Parameters
NUMBER
DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
User-Name Privilege Login-Time
15
Specifies the number of lines to display on the screen. This value
must be between 0 and 512.When the terminal length is 0, the
display will not stop until it reaches the end of the display.
0D0H3M11S
17
IP address