D-Link Dis-200G Series Cli Reference Manual page 125

poe usage-threshold
This command is used to configure the utilization threshold to record a log. Use the no form of this command
to restore to the default setting.
poe usage-threshold PERCENTAGE
no poe usage-threshold
Parameters
PERCENTAGE
Default
By default, this value is 99.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline
When the usage threshold is configured, if the utilization of the PSE exceeds the configured threshold, then the
EXCEED log will be recorded. Once the percentage decreases and become lower than the threshold, then the
RECOVER log is recorded.
Example
This example shows how to configure the usage threshold to 50%.
Switch# configure terminal
Switch(config)# poe usage-threshold 50
Switch(config)#
25-3 snmp-server enable traps poe
This command is used to enable the sending of PoE notifications. Use the no form of this command to disable
sending power over Ethernet notifications.
snmp-server enable traps poe
no snmp-server enable traps poe
Parameters
none
Default
By default, this option is disabled.
Command Mode
Global Configuration Mode.
DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
Specifies the usage threshold to generate a log. The valid range is
from 1 to 99. The unit is percentage.
121