D-Link Dis-200G Series Cli Reference Manual page 136

Switch(config)#
26-5 power-saving hibernation time-range
This command is used to configure the time range profile for the system hibernation schedule. Use the no form
of this command to delete the specified time range profile.
power-saving hibernation time-range PROFILE-NAME
no power-saving hibernation time-range PROFILE-NAME
Parameters
PROFILE-NAME
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline
Use this command to add or delete a time range profile for the system hibernation schedule. When the system
enters the hibernation mode, the Switch will go into a low power state and idle. It will shut down all the ports
and LEDs, all network function will be disabled, and only the console connection will work via the RS232 port. If
the Switch is an endpoint type Power Sourcing Equipment (PSE), the Switch will not provide power to the port.
Example
This example shows how to add a time range profile for the hibernation schedule.
Switch# configure terminal
Switch(config)# interface Ethernet 1/0/1
Switch(config)# power-saving hibernation time-range day-time
26-6 power-saving shutdown time-range
This command is used to configure the time range profile for the port shutdown schedule. Use the no form of
this command to delete the specified time range profile.
power-saving shutdown time-range PROFILE-NAME
no power-saving shutdown time-range PROFILE-NAME
Parameters
DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
Specifies the name of the time range profile to be configured. The
maximum length is 32 characters.
132