D-Link Dis-200G Series Cli Reference Manual page 89

This command enters the interface configuration mode for the specified range of interfaces.
Commands configured in the interface range mode, applies to interfaces in the range.
Example
This example shows how to enter the interface configuration mode for the range of ports 1/0/1 to 1/0/10:
Switch# configure terminal
Switch(config)# interface range Ethernet 1/0/1-10
Switch(config-if-range)#
16-5 show counters
This command is used to display interface information.
show counters [interface INTERFACE-ID]
Parameters
INTERFACE-ID
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display the statistic counters for an interface.
Example
This example shows how to display the counters for interface Ethernet 1/0/1.
Switch# show counters interface Ethernet 1/0/1
eth1/0/1 counters
rxHCTotalPkts
txHCTotalPkts
rxHCUnicastPkts
txHCUnicastPkts
rxHCMulticastPkts
txHCMulticastPkts
rxHCBroadcastPkts
txHCBroadcastPkts
rxHCOctets
txHCOctets
DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
Specifies that the interface can be a physical port. If no interface is
specified, counters of all interfaces will be displayed.
: 0
: 138
: 0
: 0
: 0
: 0
: 0
: 138
: 0
: 50094
85