Appendix A - System Log Entries - D-Link Dis-200G Series Cli Reference Manual

Appendix A - System Log Entries

The following table lists all possible entries and their corresponding meanings that will appear in the System
Log of this switch.
Auto Surveillance VLAN
Log Description
Event description: When a new surveillance device is detected on an interface.
Log Message: New surveillance device detected (<interface-id>, MAC: <mac-
address>)
Parameters description:
interface-id: Interface name.
mac-address: Surveillance device MAC address.
Event description: When an interface which is enabled surveillance VLAN joins the
surveillance VLAN automatically.
Log Message: <interface-id> add into surveillance VLAN <vid>
Parameters description:
interface-id: Interface name.
vid:VLAN ID.
Event description: When an interface leaves the surveillance VLAN and at the same
time, no surveillance device is detected in the aging interval for that interface, the log
message will be sent.
Log Message: <interface-id> remove from surveillance VLAN <vid>
Parameters description:
interface-id: Interface name.
vid:VLAN ID.
Event description: When an IPC is added in the surveillance VLAN, the log message
will be sent.
Log Message: ASV: Add IPC (IP:<ipaddr> MAC:< mac-address >)
Parameters description:
ipaddr: Represent the IP address of the IPC
mac-address: Represent the MAC address of the IPC
Event description: When an IPC is removed from the surveillance VLAN, the log
message will be sent.
Log Message: ASV: Remove IPC (IP:<ipaddr> MAC:< mac-address >)
Parameters description:
ipaddr: Represent the IP address of the IPC
mac-address: Represent the MAC address of the IPC
Event description: When an NVR is added in the surveillance VLAN, the log message
will be sent.
Log Message: ASV: Add NVR (IP:<ipaddr> MAC:< mac-address >)
Parameters description:
ipaddr: Represent the IP address of the NVR
mac-address: Represent the MAC address of the NVR
Event description: When an NVR is removed from the surveillance VLAN, the log
message will be sent.
Log Message: ASV: Remove NVR (IP:<ipaddr> MAC:< mac-address >)
Parameters description:
ipaddr: Represent the IP address of the NVR
mac-address: Represent the MAC address of the NVR
Event description: When the mode of ASV 2.0 is changed by Web GUI, the log
message will be sent.
Log Message: ASV: Mode change from <mode> to <mode>
Parameters description:
DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
254
Severity
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational