D-Link Dis-200G Series Cli Reference Manual page 207

no flowcontrol
Parameters
on
off
Default
By default, this option is disabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline
This command can only assure that the flow control capability has been configured in the Switch software and
not guarantee the actual hardware operation. The actual hardware operation may be different to the settings
that have been configured on the Switch because the flow control capability is determined by both the local
port/device and the device connected at the other end of the link, not just by the local device.
If the speed is set to the forced mode, the final flow control setting will be determined by the configured flow
control setting. If the speed is set to the auto mode, the final flow control setting will be based on the negotiated
result between the local side setting and the partner side setting. The configured flow control setting here is the
local side setting.
Example
This example shows how to enable the flow control on interface eth1/0/3.
Switch# config terminal
Switch(config)# interface Ethernet 1/0/3
Switch(config-if)# flowcontrol on
Switch(config-if)#
36-3 mdix
This command is used to configure the port Media-Dependent Interface Crossover (MDIX) state. Use the no
form of command to revert to the default setting.
mdix {auto | normal | cross}
no mdix
Parameters
auto
normal
DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
Specifies to enable a port to send PAUSE frames or process
PAUSE frames from remote ports.
Specifies to disable the ability for a port to send or receive PAUSE
frames.
Specifies to set the port interface's MDIX state to the auto-MDIX
mode.
Specifies to force the port interface's MDIX state to the normal
203