D-Link Dis-200G Series Cli Reference Manual page 236

43-2 ingress-checking
This command is used to enable ingress checking for frames received by a port. Use the no command to
disable the ingress check.
ingress-checking
no ingress-checking
Parameters
None.
Default
By default, this option is enabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline
Use this command to enable ingress checking for packets received by the interface. If ingress checking is
enabled, the packet will be dropped if the received port is not a member port of the VLAN classified for the
received packet.
Example
This example shows how to set ingress checking to enabled port eth1/0/2.
Switch# configure terminal
Switch(config)# interface Ethernet 1/0/2
Switch(config-if)# ingress-checking
Switch(config-if)#
43-3 show vlan
This command is used to display the parameters for all configured VLANs or one VLAN on the Switch.
show vlan [VLAN-ID [, | -] | interface [INTERFACE-ID [, | -]]]
Parameters
VLAN-ID
,
-
DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
(Optional) Specifies a list of VLANs to display the member port
information. If the VLAN is not specified, all VLANs are displayed.
The valid range is from 1 to 4094.
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No space before and after the
comma.
(Optional) Specifies a range of interfaces. No space before and
after the hyphen.
232