D-Link Dis-200G Series Cli Reference Manual page 81

15-2 ip igmp snooping querier
This command is used to enable the capability of the entity as an IGMP querier. Use the no form of
this command to disable the querier function.
ip igmp snooping querier
no ip igmp snooping querier
Parameters
None.
Default
By default, this option is disabled.
Command Mode
VLAN Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline
If the system can play the querier role, the entity will listen for IGMP query packets sent by other devices. If
IGMP query message is received, the device with lower value of IP address becomes the querie r.
Example
This example shows how to enable the IGMP snooping querier on VLAN 1.
Switch# configure terminal
Switch(config)# vlan 1
Switch(config-vlan)# ip igmp snooping querier
Switch(config-vlan)#
15-3 ip igmp snooping fast-leave
This command is used to configure IGMP Snooping fast-leave on the VLAN. Use the no form to disable the
fast-leave option on the specified VLAN.
ip igmp snooping fast-leave
no ip igmp snooping fast-leave
Parameters
None.
Default
By default, this option is disabled.
Command Mode
VLAN Configuration Mode.
DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
77