D-Link Dis-200G Series Cli Reference Manual page 168

Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline
This command configures the system contact information for management of the device.
Example
This example shows how to configure the system contact information with the string MIS Department.
Switch# configure terminal
Switch(config)# snmp-server contact MIS Department
Switch(config)#
32-4 snmp-server enable traps
This command is used to enable the sending of trap packets globally. Use the no form of this command to
disable the sending of trap packets.
snmp-server enable traps
no snmp-server enable traps
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline
This command enables the device to send the SNMP notification traps globally. To configure the router to send
these SNMP notifications, enter the snmp-server enable traps command to enable the global setting.
Example
This example shows how to enable the SNMP traps global sending state.
Switch# configure terminal
Switch(config)# snmp-server enable traps
DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
maximum length is 255 characters The syntax is a general string
that allows spaces.
164