D-Link Dis-200G Series Cli Reference Manual page 28

NETWORK-PREFIX
NETWORK-MASK
IP-ADDRESS
Default
none.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 15
Usage Guideline
Use this command to configure static route that destination is default gateway. The net-address and net-mask
only allow to configure with 0.0.0.0.
Example
This example shows how to configure the static route that destination is to 10.90.90.254.
Switch# config terminal
Switch(config)# ip route 0.0.0.0 0.0.0.0 10.90.90.254
Switch(config)#
show ip interface
5-3
This command is used to display the IP interface information.
show ip interface brief
Parameters
None.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display ip address information of the management interface.
Example
This example shows how to display the brief information of the IP interface.
Switch# show ip interface brief
DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
Specifies the network address.
Specifies the network mask
Specifies to an IP address.
24