D-Link Dis-200G Series Cli Reference Manual page 58

no rpl
Parameters
port0
port1
owner
Default
None.
Command Mode
ERP Instance Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline
This command is used to configure the node as the RPL owner or RPL neighbor, or assign the port as the RPL
port.
Example
This example shows how to configure port0 as the RPL port of the ERP instance "1".
Switch# configure terminal
Switch(config)# ethernet ring g8032 ring1
Switch(config-erp)# instance 1
Switch(config-erp-instance)# rpl port0
Switch(config-erp-instance)#
11-13 show ethernet ring g8032
This command is used to display information of the ERP instances.
show ethernet ring g8032 {status | brief}
Parameters
status
brief
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
Specified port0 as the RPL port.
Specified port1 as the RPL port.
(Optional) Specifies the ring node as the RPL owner node.
Specifies to display the status of the ERP instances.
Specifies to display the brief information of the ERP instances.
54