D-Link Dis-200G Series Cli Reference Manual page 128

Switch# show poe power-inline configuration
Interface
-----------------------------------------------------
eth1/0/1
eth1/0/2
eth1/0/3
eth1/0/4
eth1/0/5
eth1/0/6
eth1/0/7
eth1/0/8
Switch#
Display Parameters
Interface
Admin
Priority
Time-Range
25-5 show poe power module
This command is used to display the setting and actual values of the power modules.
show poe power module
Parameters
none
Default
None
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command displays the detailed power information and PoE chip parameters for PoE modules.
DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
Admin Priority Time-Range
auto low
auto low
auto low day-time
auto low
auto low
auto low
auto low
auto low
The PoE interface ID.
The user configured mode can be of the following:
Auto - The powered device will be automatically detected and
maximum power is based on the detection result.
Never - The powered device will not be detected, and no power to
the port.
The priority used to prioritize the service order when power
constrain happens within at the power unit.
The time-range profile name which sets the activation time frame
for a port.
124