D-Link Dis-200G Series Cli Reference Manual page 113

23-2 ipv6 mld snooping querier
This command is used to enable the MLD snooping querier on the Switch. Use the no form of this command to
disable the MLD snooping querier function.
ipv6 mld snooping querier
no ipv6 mld snooping querier
Parameters
None.
Default
By default, this option is disabled.
Command Mode
VLAN Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline
The command is only available for VLAN interface configuration.
Example
This example shows how to enable the MLD snooping querier state on VLAN 1.
Switch# configure terminal
Switch(config)# vlan 1
Switch(config-vlan)# ipv6 mld snooping querier
Switch(config-vlan)#
23-3 ipv6 mld snooping fast-leave
This command is used to configure MLD snooping fast-leave on the interface. Use the no form of this
command to disable the fast-leave option on the specified interface.
ipv6 mld snooping fast-leave
no ipv6 mld snooping fast-leave
Parameters
None.
Default
No static-group is configured.
Command Mode
VLAN Configuration Mode.
Command Default Level
Level: 15.
DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
109