D-Link Dis-200G Series Cli Reference Manual page 87

Interface Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline
The specified description corresponds to the MIB object "ifAlias" defined in the RFC 2233. Notice that space is
not alllowed in the description.
Example
This example shows how to add the description "Port10" to interface Ethernet 1/0/10.
Switch# configure terminal
Switch(config)# interface Ethernet 1/0/10
Switch(config-if)# description Port10
16-3 interface
This command is used to enter the interface configuration mode for a single interface. Use the no form of this
command to remove an interface.
interface INTERFACE-ID
no interface INTERFACE-ID
Parameters
INTERFACE-ID
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline
This command enters the interface configuration mode for a specific interface. The format of the interface
number is dependent on the interface type. For physical port interfaces, the user cannot enter the interface if
the Switch's port does not exist. The physical port interface cannot be removed by the no command.
Use the interface vlan command to create Layer 3 interfaces. Use the vlan command in the global
configuration mode to create a VLAN before creating Layer 3 interfaces. Use the no interface vlan
command to remove a Layer 3 interface.
The port channel interface is automatically created when the channel-group command is configured
for the physical port interface. A port channel interface will be automatically removed when no
DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
Specifies the ID of the interface. The interface ID is formed by
interface type and interface number. The interface types are as
follows:
ethernet - Ethernet switch port with all different media.
vlan - VLAN interface.
port-channel - Aggregated port channel interface.
range - Enter the interface range configuration mode for multiple
interfaces.
83