D-Link Dis-200G Series Cli Reference Manual page 97

19-2 show channel-group
This command is used to display the channel group information.
show channel-group [channel [CHANNEL-NO] {detail | neighbor} | load-balance | sys-id]
Parameters
CHANNEL-NO
channel
detail
neighbor
load-balance
sys-id
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
If a port-channel number is not specified, all port-channels will be displayed. If the channel, load- balance and
sys-id keywords are not specified with the show channel-group command, only summary channel-group
information will be displayed.
Example
This example shows how to display the detailed information of all port-channels.
Switch# show channel-group channel detail
Flag:
S - Port is requesting Slow LACPDUs F - Port is requesting fast LACPDU
A - Port is in active mode P - Port is in passive mode
LACP state:
bndl: Port is attached to an aggregator and bundled with other ports.
hot-sby: Port is in a hot-standby state.
indep: Port is in an independent state(not bundled but able to switch data
traffic)
down: Port is down
Channel Group 1
DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
(Optional) Specifies the channel group ID.
(Optional) Specifies to display information for the specified port-
channels.
(Optional) Specifies to display detailed channel group information.
(Optional) Specifies to display neighbor information.
(Optional) Specifies to display the load balance information.
(Optional) Specifies to display the system identifier that is being
used by LACP.
93