D-Link Dis-200G Series Cli Reference Manual page 33

None.
Command Mode
EXEC Mode.
Command Default Level
Level: 1.
Usage Guideline
This command is used to display the test results for the cable diagnostics.
Example
This example shows how to display the test results for the cable diagnostics.
Switch# show cable-diagnostics interface Ethernet 1/0/1-2
Port
--------- ---------- ------------- ------------------------- -----------------
eth1/0/1
eth1/0/2
7-3 clear cable-diagnostics
This command is used to clear the test results for the cable diagnostics.
clear cable-diagnostics {all | interface INTERFACE-ID}
Parameters
all
interface INTERFACE-ID
Default
None.
Command Mode
EXEC Mode.
Command Default Level
Level: 15.
DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
Type Link Status
1000BaseT Link Down
1000BaseT Link Down
Test Result
Pair 1 Open at
Pair 2 Open at
Pair 3 Short at
Pair 4 OK at
Pair 1 Open at
Pair 2 Open at
Pair 3 Short at
Pair 4 OK at
Specifies to clear cable diagnostics results for all
interfaces.
Specifies the interface's ID. The acceptable interface
will be a physical port.
29
Cable Length (M)
<7M -
<7M -
<7M -
<7M -
<7M -
<7M -
<7M -
<7M -