D-Link Dis-200G Series Cli Reference Manual page 61

Port-State
status
brief
11-14 activate
This command is used to activate the specified ERP instance. Use the no form of this command to deactivate
the specified ERP instance.
Activate
no activate
Parameters
None.
Default
By default, this option is no activate.
Command Mode
ERP Instance Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline
This command is used to activate or deactivate the specified ERP instance. The ring ports, APS channel, and
ERP profile must be configured before activating the ERP instance.
The activated ERP instance will be in non-operational state, if the specified APS channel does not exist, or the
specified ports are not the tagged member port of the APS channel VLAN.
Example
This example shows how to activate the instance 1.
Switch# configure terminal
Switch(config)# ethernet ring g8032 ring1
Switch(config-erp)# instance 1
Switch(config-erp-instance)# activate
Switch(config-erp-instance)#
timer
11-15
This command is used to configure timers for an ERP domain. Use the no form of this command to revert to the
default settings.
timer {guard MILLI-SECONDS | hold-off SECONDS | wtr MINUTES}
DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
Current ring ports state. (- / Forwarding / Blocked)
Specifies to display the status of the ERP instances.
Specifies to display the brief information of the ERP instances.
57