D-Link Dis-200G Series Cli Reference Manual page 116

vlan VLAN-ID
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display MLD group information by command.
Example
This example shows how to display MLD snooping group information.
Switch# show ipv6 mld snooping groups
MLD Snooping Connected Group Membership:
VLAN ID Group address
------- ----------------- --------------------- -- -------- ---------
1 ff09::2
1 ff09::c
1 ff09::fb
Total Groups : 3, Total SSM entries : 3
Switch#
23-7 show ipv6 mld snooping static-group
This command is used to display MLD snooping static group information on the Switch.
show ipv6 mld snooping static-group [GROUP-ADDRESS | vlan VLAN-ID]
Parameters
GROUP-ADDRESS
vlan VLAN-ID
Default
None.
Command Mode
DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
(Optional) Specifies the VLAN interface. If no interface is specified,
MLD group information about all interfaces will be displayed.
Source address
2015:2016::2017:2018
Specifies the group IPv6 address to be displayed.
Specifies the VLAN ID to be displayed.
FM Exp(sec) Interface
IN
* EX
* IN
112
260 eth1/0/1
200 eth1/0/2
245 eth1/0/3