Installing Hydraulics; Installing Hydraulic Lines And Hoses - MacDon R113 Installation Instructions Manual

3.3 Installing Hydraulics

This section explains how to install the transport hydraulic control system.

3.3.1 Installing Hydraulic Lines and Hoses

NOTE:
The cover support bracket has been removed from the illustrations for clarity.
NOTE:
Refer to the pull-type operator's manual or technical manual for hydraulic fitting installation details.
1. Retrieve steel lines and hoses from shipping bag.
2. Place a container or rag under the fitting on the hitch
swing cylinder to catch oil.
3. Remove existing fitting (A) from the block.
4. Remove cap (B) from tee fitting.
IMPORTANT:
Ensure O-ring is in place.
5. Retrieve ORFS-6 x ORB-6 connector (B) (MD #136147) from
the shipping bag and install at location (A).
NOTE:
Ensure that the direction arrow on check valve (D) points
away from tee fitting (C).
214633
INSTALLATION INSTRUCTIONS
Figure 3.38: Alignment Valve Fitting
C
Figure 3.39: Alignment Valve Fitting
27
B
A
D
B
A
Revision C