Completing Transport System Installation; Removing Cover; Installing Transport Alignment Control - MacDon R113 Assembly Instruction Manual

ASSEMBLING THE ROTARY DISC PULL-TYPE – FACTORY-INSTALLED TRANSPORT

4.8 Completing Transport System Installation

This section describes the installation of the base components, the hydraulic lines and hoses, and the electrical connections
for the transport system.

4.8.1 Removing Cover

1. Remove bolts (B) from cover (A).
2. Remove cover (A).

4.8.2 Installing Transport Alignment Control

The transport alignment control ensures that the pull-type can only go into or out of transport mode from a specific
position.
1. Secure cam assembly (A) onto hitch swing cylinder plate (B)
with bolts and nuts (C). Torque nuts (C) to 58 Nm (43 lbf·ft).
NOTE:
When installing cam assembly (A), check for hose twisting.
If required, loosen hose fitting to allow hose to untwist.
Torque fitting once complete.
215585
Figure 4.60: Cover – Top View
Figure 4.61: Alignment Control – Rear Right View
85
Revision A