Commands In The Global Configuration Mode; Events; Commands In The Events Configuration Mode - Siemens SCALANCE W770 Series Configuration Manuals

12.1.5

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can be
found in the relevant sections.
You exit the Global configuration mode with the end or exit command and are then in the
Privileged EXEC mode again.
12.1.5.1

events

Description
With this command, you change to the EVENTS configuration mode.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
events
Result
You are now in the EVENTS configuration mode.
The command prompt is as follows:
cli(config-events)#
Further notes
You exit the EVENTS configuration mode with the command end or exit.
12.1.6

Commands in the Events configuration mode

This section describes commands that you can call up in the EVENTS configuration mode.
In the Global configuration mode, enter the events command to change to this mode.
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Diagnostics
12.1 Diagnostics
589