Show Wlan Allowed Channels - Siemens SCALANCE W770 Series Configuration Manuals

Network structures
7.1 WLAN
Result
The following settings are displayed:
● RTS/CTS threshold
● Fragmentation length threshold
● HW retries
In Access Point mode, the following additional settings are displayed:
● Beacon interval
● DTIM
● Force roaming on link down
● Overlap AP aging interval
7.1.1.2

show wlan allowed channels

Description
This command displays the available wireless channels. If you have selected channels
explicitly for wireless communication, this information is also displayed.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show wlan allowed channels <wlan 0/X>
The parameter has the following meaning:
Parameter
wlan 0/X
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 29)".
Result
The list of wireless channels available for establishing a wireless link to the relevant WLAN
interface is displayed.
186
Description
WLAN interface
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Range of values / note
Enter a valid interface.
Configuration Manual, 09/2017, C79000-G8976-C324-08