Commands In The Interface Configuration Mode; Ipv6 Dhcp Client Request - Siemens SCALANCE W770 Series Configuration Manuals

The parameters have the following meaning:
Parameter
interface
vlan
vlan-id
interface-
type
interface-
id
For information on names of addresses and interfaces, refer to the section "Interface identifiers
and addresses (Page 29)".
If no parameters are specified, the statistics for all interfaces are displayed.
Result
The statistics are displayed.
Further notes
You can reset the counter to zero with the command clear ipv6 dhcp client
statistics.
8.4.3

Commands in the Interface configuration mode

This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the interface command to change to this mode.
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the exit command, you return to the Global
configuration mode.
● If you exit the Interface configuration mode with the end command, you return to the
Privileged EXEC mode.
8.4.3.1

ipv6 dhcp client request

Description
With this command you specify which configuration parameters will be requested, e.g. the IPv6
address of the DNS server.
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Description
Shows that an interface description follows
Keyword for a VLAN connection
Number of the addressed VLAN
Type or speed of the interface
Module no. and port no. of the interface
Network protocols
8.4 DHCPv6 client (IPv6)
Range of values / note
-
-
1 ... 4094
Specify a valid interface.
385