Cli-Console-Timeout - Siemens SCALANCE W770 Series Configuration Manuals

Configuration
4.1 System
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no interface{vlan<vlan-id(1-4094)>}
The parameters have the following meaning:
Parameter
vlan
vlan-id
Result
The logical interface is deleted.
Further notes
You configure an interface with the interface command.
You display the status and the configuration of the interfaces with the show interfaces
command.
4.1.10.7

cli-console-timeout

Description
With this command, you enable the automatic logout and you configure the timeout setting for
the CLI.
Note
No automatic logout from the CLI
If the connection is not terminated after the set time, check the setting of the "keepalive"
function on the Telnet client. If the set interval is shorter than the configured time, the lower
value applies. You have set, for example, 300 seconds for the automatic logout and 120
seconds for the "keepalive" function. In this case, a packet is sent every 120 seconds that
keeps the connection up.
Requirement
You are in the Global configuration mode.
70
Description
Keyword for a VLAN connection
Number of the addressed VLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Range of values / note
-
1 ... 4094
Configuration Manual, 09/2017, C79000-G8976-C324-08