Ping Ipv6 - Siemens SCALANCE W770 Series Configuration Manuals

Configuration
4.1 System
At system start or when using the restart command with the option memoryor factory,
the following defaults apply:
Parameter
size
count
timeout
Result
The messages relating to the response of the called node are displayed.
4.1.9

ping ipv6

Description
With this command, you request a response from a device in the network. This allows you to
check whether or not another node is reachable.
Requirement
● IPv6 is enabled.
● You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
ping ipv6 { <prefix%interface> | fqdn-name <FQDN> } [repeat <count>]
[size <value>] [anycast] [source {vlan <id> | <source_prefix>}]
[timeout <value (1-100)>]
The parameters have the following meaning:
Parameter
prefix
%interface
fqdn-name
FQDN
repeat
64
Default value
32
3
1
Description
IPv6 address of the destination
optional parameter
Only necessary when the IPv6 ad‐
dress of the destination is a link-local
address.
Keyword for a domain name
Domain name (Fully Qualified Do‐
main Name) of the called node
Keyword for the number of packets to
be requested
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Range of values / note
Enter a valid IPv6 address.
Specify the interface via which the
packet will be sent.
-
Maximum of 100 characters
-