Wlan Alternative Channel (Access Point) - Siemens SCALANCE W770 Series Configuration Manuals

Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call the command without parameter assignment:
no wlan allowed channels only
Result
The function is disabled.
Further notes
You display the setting with the show wlan allowed channels <wlan 0/X> command.
You enable the function with the wlan allowed channels only command.
See also
wlan allowed channels only (Page 212)
7.1.5.4

wlan alternative channel (access point)

Description
If you have activated the DFS function, you specify the alternative channel with this command.
If the access point on the current channel discovers a disruption, it switches to the alternative
channel.
Note
This command is available only in access point mode.
Requirement
● The DFS function is enabled.
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Network structures
7.1 WLAN
213