No Firmeware-In-Configpack; Reset And Defaults; Restart - Siemens SCALANCE W770 Series Configuration Manuals

Further notes
You disable the setting with the no firmeware-in-configpack command.
4.2.5.13

no firmeware-in-configpack

Description
With this command you take firmware file out of the ConfigPack file.
Requirement
You are in the LOADSAVE configuration mode.
The command prompt is as follows:
cli(config-loadsave)#
Syntax
Call the command without parameter assignment:
no firmeware-in-configpack
Result
The function is disabled.
Further notes
You enable the function with the firmeware-in-configpack command.
4.3

Reset and Defaults

This section describes commands for restarting the device and for restoring the original
configuration.
4.3.1

restart

Description
With this command, you restart the device.
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Configuration
4.3 Reset and Defaults
99