No Nat Timeout (Client) - Siemens SCALANCE W770 Series Configuration Manuals

Simatic net industrial wireless lan ieee 802.11n command line interface

Table of Contents

no nat timeout (Client)

This command is only available in the client mode.

With this command, you delete the time period for the TCP / UDP connection.

You are now in the NAT Configuration mode.

The command prompt is as follows:

cli(config-nat)#

Call up the command with the following parameters:

no nat {tcp|udp} timeout

The parameters have the following meaning:

The time period for the TCP / UDP connection was set to the default setting.

Further notes

You show the NAT configuration and the translation list with the show nat command.

You configure the time with the nat timeout command.

Table of Contents