Ipcf; The "Show" Commands; Show Wlan Ipcf - Siemens SCALANCE W770 Series Configuration Manuals

5.4

iPCF

This section describes the commands relevant for working with the iPCF function (industrial
Point Coordination Function).
Note
This commands are only available with the following KEY-PLUGs:
● W780 iFeatures (MLFB 6GK5 907-8PA00)
● W740 iFeatures (MLFB 6GK5 907-4PA00)
5.4.1

The "show" commands

This section describes commands with which you display various settings.
5.4.1.1

show wlan ipcf

Note
This commands are only available with the following KEY-PLUGs:
● W780 iFeatures (MLFB 6GK5 907-8PA00)
● W740 iFeatures (MLFB 6GK5 907-4PA00)
Note
This command is only available with the following KEY-PLUG:
● W740 iFeatures (MLFB 6GK5 907-4PA00)
Description
This command shows the settings of iPCF.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Functions specific to SCALANCE
5.4 iPCF
123