No Ipv6 Address - Siemens SCALANCE W770 Series Configuration Manuals

Result
The IPv6 address is assigned to the interface. If you assign a link local address to the IP
interface, the automatically created local address is overwritten.
Further notes
You delete the IPv6 address with the no ipv6 address command.
You enable IPv6 with the ipv6 enable command.
You display this setting and other information with the show ipv6 interface command.
You enable stateless autoconfiguration with the command ipv6 address autoconfig.
You enable stateful autoconfiguration with the command ipv6 address dhcp.
8.2.4.2

no ipv6 address

Description
With this command, you delete the IPv6 address.
Requirement
● IPv6 is activated
● The interface is an IP interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call up the command with the following parameters:
no ipv6 address <prefix> <prefix-length> [{unicast | eui64}]
The parameters have the following meaning:
Parameter
prefix
prefix Len
unicast
eui-64
link-local
For information on names of addresses and interfaces, refer to the section "Interface identifiers
and addresses (Page 29)".
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Description
IPv6 address
Number of bits belonging to the prefix
(from left to right)
Addressing mode unicast
Interface ID according to the EUI-64 meth‐
od
Link local address
Network protocols
8.2 IPv6 protocol
Range of values / note
Enter a valid IPv6 address.
1 ... 128 bits
-
-
-
371