No Snmp Targetaddr; Snmp Targetparams - Siemens SCALANCE W770 Series Configuration Manuals

Network protocols
8.6 SNMP
Further notes
You delete the SNMP target address with the no snmp targetaddr command.
You display the SNMP target address with the show snmp targetaddr command.
You configure the SNMP target parameters with the snmp targetparams command.
You display the SNMP target parameters with the show snmp targetparam command.
You store trhe domain name with the ip domain name or domain name command.
8.6.2.17

no snmp targetaddr

Description
With this command, you delete the SNMP target address.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no snmp targetaddr <TargetAddressName>
The parameter has the following meaning:
Parameter
TargetAddressName
Result
The SNMP target address is deleted.
Further notes
You change the SNMP target address with the snmp targetaddr command.
You display the SNMP target address with the show snmp targetaddr command.
8.6.2.18

snmp targetparams

Description
With this command, you configure the SNMP target parameters.
428
Description
SNMP target address
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Range of values / note
max. 32 characters
Configuration Manual, 09/2017, C79000-G8976-C324-08