Wlan Frequency Band (Access Point) - Siemens SCALANCE W770 Series Configuration Manuals

Requirement
● The transmission standard 802.11g or 802.11a is set.
● You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call up the command with the following parameters:
wlan fragmentation threshold <bytes(256-2346)>
The parameter has the following meaning:
Parameters
bytes
Result
The packet size is specified.
Further notes
You configure the transmission standard with the wlan mode command.
You display the setting with the show wlan advanced <wlan 0/X> command.
7.1.5.49

wlan frequency band (access point)

Description
With this command, you specify the frequency band for the WLAN interface.
Note
This command is available only in access point mode.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Description
Packet size in bytes
Range of values / note
256...2346
Default: 2346
Network structures
7.1 WLAN
251