Table of Contents
Advertisement
11.4.3.1
mac access-group
Description
With this command, you enable the access control of the packets of an interface.
Requirement
● A MAC access control list has been created.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
mac access-group <access-list-number(1-20)>{in|out}
The parameters have the following meaning:
Parameter
access-list-
number
in
out
Result
The packets are filtered according to the access control list (ACL).
Further notes
You disable the setting with the no mac access-group command.
You display the statistical data of the access control list with the show access-lists
command.
11.4.3.2
no mac access-group
Description
With this command, you disable the access control of the packets of an interface.
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Description
Number of the access control list
Specifies that incoming packets are fil‐
tered
Specifies that outgoing packets are fil‐
tered
Security and authentication
11.4 MAC access control list
Range of values / note
1 ... 20
-
-
549
Hide quick links:
Advertisement
Table of Contents
