Dhcpv6 Client (Ipv6); Clear Ipv6 Dhcp Client Statistics - Siemens SCALANCE W770 Series Configuration Manuals

Simatic net industrial wireless lan ieee 802.11n command line interface

Table of Contents

Network protocols

8.4 DHCPv6 client (IPv6)

DHCPv6 client (IPv6)

This section describes commands for DHCPv6.

With this command, you reset the counter to zero on the required interface.

● DHCPv6 is enabled.

You are in the Privileged EXEC mode.

The command prompt is as follows:

Call up the command with the following parameters:

clear ipv6 dhcp client statistics [interface {vlan <vlan-id(1-4094)>

|<interface-type> <interface-id>}]

The parameters have the following meaning:

For information on identifiers of addresses and interfaces, refer to the section "Interface

identifiers and addresses (Page 29)".

If no parameters are specified, all counters are reset.

The counter is reset.

Further notes

You enable DHCPv6 with the ipv6 address dhcp command.

Shows that an interface description follows

Keyword for a VLAN connection

Number of the addressed VLAN

Type or speed of the interface

Module no. and port no. of the interface

SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface

Range of values / note

Enter a valid interface.

Configuration Manual, 09/2017, C79000-G8976-C324-08

Show Quick Links

Table of Contents