Table of Contents
Advertisement
Network structures
7.2 VLAN
Further notes
You can reset the setting to the default with the no switchport access vlan command.
You display the setting and other information with the show vlan port config command.
7.2.3.3
no switchport access vlan
Description
With this command, you reset the setting for the port VLAN identifier (PVID) for an interface
to the default value.
The default value is 1.
Requirement
You are in the interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no switchport access vlan
Result
The setting is reset to the default value.
Further notes
You configure the setting with the switchport access vlan command.
You can display the status of this function and other information with the show vlan port
configcommand.
7.2.3.4
switchport ingress-filter
Description
With incoming packets, the ingress filter checks whether the port on which the packet was
received belongs to the sending VLAN. If this is not the case, the packet is not processed.
With this command, you enable the ingress filter.
292
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Hide quick links:
Advertisement
Table of Contents
