No Ip Route - Siemens SCALANCE W770 Series Configuration Manuals

The parameter has the following meaning:
Parameter
gateway
Result
The entry is configured.
Further notes
You delete an entry from the IP routing table with the no ip route command.
You display the IP routing table with the show ip route command.
8.1.2.6

no ip route

Description
With this command, you delete a static entry from the IP routing table.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no ip route <gateway>
The parameter has the following meaning:
Parameter
gateway
Result
The entry is deleted.
Further notes
You configure an entry from the IP routing table with the ip route command.
You display the IP routing table with the show ip route command.
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Description
Specifies the IP address of the gateway
Description
Specifies the IP address of the gateway.
Network protocols
8.1 IPv4 protocol
Range of values / note
enter a valid IP address
Range of values / note
Specify a valid IP address.
349