Wlan Signal-Recorder Display Sample_Number (Client) - Siemens SCALANCE W770 Series Configuration Manuals

Result
The recording is configured and will be started. The measured values are output in the CLI
and logged in files. If these files already exist, they will be overwritten.
Use the wlan signal-recorder <wlan 0/X> stop command to stop the recording.
During the recording, it is possible that working in the CLI becomes slower.
Further notes
You stop the recording early with the wlan signal-recorder <wlan 0/X> stop
command.
You display the status of the signal recorder and the recording with the show wlan signal-
recorder <wlan 0/X> command.
5.3.5

wlan signal-recorder display sample_number (Client)

Description
With this command, you configure and start recording with the signal recorder. The measured
values are output in the CLI and logged in files. On completion of the recording, the files can
be downloaded as a zip file using http or tftp. The values are stored every 10 minutes. The file
contains all values since the start of the recording.
Note
This command is only available in the client mode.
Requirement
● The WLAN interface is enabled.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
wlan signal-recorder <wlan 0/X> <ms (100 - 60000)> <sample_number (1
- 20000)> [bidirectional] display
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Functions specific to SCALANCE
5.3 Signal recorder
121