No Option - Siemens SCALANCE W770 Series Configuration Manuals

Network protocols
8.5 DHCP server
Syntax
Call up the command with the following parameters:
option <option-code> value-string <dhcp-param>
The parameters have the following meaning:
Parameter
option-
code
dhcp-param
Result
The DHCP option is configured.
Further notes
You display the setting with the show ip dhcp-server pools command.
You delete the DHCP option with the no option command.
You configure the DHCP options 3 and 6 with the option (IP address) command.
You disable the IPv4 address band with the no pool-enable command.
8.5.3.6

no option

Description
With this command, you delete the DHCP option with the specified number.
Requirement
You are in the DHCPPOOL configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
Syntax
Call up the command with the following parameters:
no option <option-code>
The parameter has the following meaning:
Parameter
option-code
400
Description
Code of the DHCP option
Name of the file
Description
Code of the DHCP option
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Range of values / note
● 12 - Host name
● 66 - TFTP server
● 67 - Bootfile name
Enter the name in the string format.
Range of values / note
Enter a valid DHCP option code.
Configuration Manual, 09/2017, C79000-G8976-C324-08