Commands In The Global Configuration Mode; Authorized-Manager Ip-Source - Siemens SCALANCE W770 Series Configuration Manuals

Security and authentication
11.6 Management Access Control List
11.6.2

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can be
found in the relevant sections.
You exit the Global configuration mode with the end or exit command and are then in the
Privileged EXEC mode again.
11.6.2.1

authorized-manager ip-source

Description
With this command, you configure the interfaces and protocols via which an authorized
manager is allowed to access the device.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
authorized-manager ip-source <ip-address>
[vlan<a,b or a-b or a,b,c-d>]
[ssh]]
The parameters have the following meaning:
Parameter
ip-address
subnet-mask
prefix-
length
interface
interface-
type
0/a-b,0/
c,...
vlan
578
[{<subnet-mask>|/<prefix-length(0-32)>}]
[interface[<interface-type<0/a-b,0/c,...>]
[<interface-type<0/a-b,0/c,...>]]
Description
Specifies the network or the IP address for which
the IP manager is authorized
Subnet mask that restricts the authorization
Decimal representation of the mask as a number
of "1" bits
Keyword for a an interface description
Type or speed of the interface
Module no. and port no. of the interface
Keyword for a VLAN connection
[service[snmp][telnet][http][https]
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Range of values / note
Enter a valid IPv4 address or a
network
Enter a valid mask
0 .. 32
-
Enter a valid interface.
-