Clear Spanning-Tree Counters; Commands In The Global Configuration Mode - Siemens SCALANCE W770 Series Configuration Manuals

Parameter
max-age
port
priority
detail
Result
The settings of the root bridge for the spanning tree function are displayed.
7.3.2

clear spanning-tree counters

Description
With this command, you reset all the statistical counters of the spanning tree function at the
device and port level.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
clear spanning-tree counters
Result
The spanning tree counters are reset.
7.3.3

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can be
found in the relevant sections.
You exit the Global configuration mode with the end or exit command and are then in the
Privileged EXEC mode again.
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Description
Shows the maximum age of the data packet after which it is deleted
Shows the interface via which the spanning tree is set up
Shows the priority of the bridge
Shows detailed information about the root bridge
Network structures
7.3 Spanning Tree
309