Table of Contents
Advertisement
Network structures
7.1 WLAN
7.1.1.14
show wlan noise-floor
Description
This command shows the background noise of the channel at the antenna connector. If
available the background noise of the extended channel (HT-40) is displayed.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameter assignment:
show wlan noise-floor
Result
The background noise is displayed.
7.1.1.15
show wlan overlap-ap-list (access point)
Description
This command shows all access points that are visible on the set or adjacent channels (at 2.4
GHz). If entries exist here, the maximum data throughput of the access point will be restricted.
Note
This command is available only in access point mode.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show wlan overlap-ap-list <wlan 0/X>
196
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Hide quick links:
Advertisement
Table of Contents
