Show Spanning-Tree L2T-Edge - Siemens SCALANCE W770 Series Configuration Manuals

Parameter
rootcost
restricted-role
restricted-tcn
state
stats
detail
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 29)".
Result
The settings of the ports for the spanning tree function are displayed.
7.3.1.6

show spanning-tree l2t-edge

Description
This command displays the status of the layer 2 tunnel ports.
Note
This command is available only in access point mode.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameter assignment:
show spanning-tree l2t-edge
Result
The status of the layer 2 tunnel ports is displayed.
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Description
Shows the costs of the path to the root
bridge.
Shows whether spanning-tree
restricted-role is enabled.
Shows whether spanning-tree
restricted-tcn is enabled.
Shows the status of the interface.
Shows the counters of the various
BPDU transmissions.
Shows detailed information about the
spanning tree settings of the interface.
Network structures
7.3 Spanning Tree
Range of values / note
-
-
-
-
-
-
305