Show Mac-Address-Table Aging-Status; Commands In The Global Configuration Mode; Mac-Address-Table Aging-Time - Siemens SCALANCE W770 Series Configuration Manuals

Load control
9.1 Dynamic MAC aging
9.1.1.2

show mac-address-table aging-status

Description
This command shows whether or not MAC aging is enabled.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show mac-address-table aging-status
Result
The status of the MAC aging is displayed.
9.1.2

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can be
found in the relevant sections.
You exit the Global configuration mode with the end or exit command and are then in the
Privileged EXEC mode again.
9.1.2.1

mac-address-table aging-time

Description
With this command, you configure the aging of a dynamically learned entry in the MAC address
list.
Note
Addresses with light data traffic
For addresses with low data traffic, it is recommended to enter a higher value for the aging.
452
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08