Commands In The Interface Configuration Mode; Ip Access-Group - Siemens SCALANCE W770 Series Configuration Manuals

Simatic net industrial wireless lan ieee 802.11n command line interface

Table of Contents

The parameters have the following meaning:

access-list-

The access control list is deleted.

Further notes

You generate an IP access control list with the ip access-list command.

You display the configuration of the access control list with the show access-lists

Commands in the Interface Configuration mode

This section describes commands that you can call up in the interface configuration mode.

Depending on the Interface selected, various command sets are available.

In the Global configuration mode, enter the interface command to change to this mode.

Commands relating to other topics that can be called in the interface configuration mode can

be found in the relevant sections.

● If you exit the Interface configuration mode with the exit command, you return to the Global

configuration mode.

● If you exit the Interface configuration mode with the end command, you return to the

Privileged EXEC mode.

With this command, you enable the access control of the packets of an interface.

● An IP access list has been created.

● You are in the Interface configuration mode

.The command prompt is:

cli(config-if-$$$)#

SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface

Configuration Manual, 09/2017, C79000-G8976-C324-08

Specifies that a standard access control

list is generated

Number of the standard access control

Security and authentication

11.5 IP access control list

Range of values / note

Show Quick Links

Table of Contents