The "Show" Commands; Show Wlan Spectrumanalyzer (Access Point) - Siemens SCALANCE W770 Series Configuration Manuals

Functions specific to SCALANCE
5.9 Spectrum analyzer
Which the spectrum analyzer you can recognize and represent the electromagnetic signals of
a frequency range. You can measure the strength of all signals located in the environment of
the access point.
Note
Spectrum analyzer in the change mode "Manual Commit".
We recommend that you do not use the spectrum analyzer in the change mode "Manual
Commit".
5.9.1

The "show" commands

This section describes commands with which general system properties can be displayed and
configured.
5.9.1.1

show wlan spectrumanalyzer (Access Point)

Description
This command shows the settings of the spectrum analyzer.
Note
This command is available only in access point mode.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameter assignment:
show wlan spectrumanalyzer
Result
The settings of the spectrum analyzer are displayed.
156
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08