Switchport Pvid - Siemens SCALANCE W770 Series Configuration Manuals

The default value is 0.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no switchport priority default
Result
The setting is reset to the default value.
Further notes
You configure the priority default with the switchport priority default command.
You display this setting and other information with the show vlan port config command.
7.2.3.8

switchport pvid

Description
With this command, you assign an interface to a VLAN and configure the port VLAN identifier
(PVID) for it. If a received frame has no VLAN tag, it has a tag added with the VLAN ID specified
here and is sent according to the switch rules for the port.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
switchport pvid <vlan-id(1-4094)>
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Network structures
7.2 VLAN
295