No Wlan Aeroscout; Spectrum Analyzer - Siemens SCALANCE W770 Series Configuration Manuals

Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call the command without parameters:
wlan aeroscout
Result
AeroScout is enabled.
5.8.2.2

no wlan aeroscout

Description
With this command, you disable AeroScout for the specified WLAN interface.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call the command without parameters:
wlan no aeroscout
Result
AeroScout is disabled.
5.9

Spectrum analyzer

This section describes the commands relevant for working with the spectrum analyzer.
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Functions specific to SCALANCE
5.9 Spectrum analyzer
155